Tankless units are reliable, and when they fail they usually tell you why, through an error code, a temperature that will not hold or a unit that will not fire. Most faults come from a short list of causes.
The usual tankless faults are scale in the heat exchanger from hard water, a blocked vent or air intake, a dirty inlet screen, a failed sensor or igniter, a gas supply too small for the unit, and cold-water sandwich effects from low flow. Many are fixed by flushing and cleaning, and the rest by replacing a part. Check the error code in the manual first.
- Error codes point to the cause. Look it up before calling.
- Scale is the most common cause in Houston, and flushing prevents it.
- Low flow or a small gas line can make a good unit act faulty.
- A unit that will not fire may have no gas, a blocked vent or a failed igniter.
- Annual service avoids most failures.
Common faults and what they usually mean
| Symptom | Likely cause | Usual fix |
|---|---|---|
| Error code, then shutdown | Sensor, vent or flame fault | Check the code, clean or replace the part |
| Lukewarm or fluctuating temperature | Scale, low flow or a dirty screen | Descale, clean the inlet filter |
| No hot water | Gas off, blocked vent, failed igniter | Check supply and vent, replace the part |
| Takes long to heat | Scale, long pipe run, low flow | Descale, review the setup |
| Loud rumbling or whistling | Scale or high flow through a restricted exchanger | Descale |
| Water too hot | Faulty sensor or set point | Check the setting and the sensor |
What you can check
- Is the power on, and is the display lit?
- Is the gas valve open, and do other gas appliances work?
- What does the error code say?
- Are other taps running hot water at the same time?
- Is the inlet filter clean?
Flushing and service
A tankless unit should be flushed with a descaling solution on the manufacturer's schedule, more often in hard water. Isolation valves make this easy. A softener helps. See our page on water softener installation.
When to repair, when to replace
Most faults are repairable. A failed heat exchanger on an older unit may not be worth replacing. A plumber can tell you.
For repair see tankless water heater repair and our water heater experts.
Frequently asked questions
Why does my tankless water heater show an error code?
It has detected a fault. The code in the manual points to the cause.
How often should a tankless unit be flushed?
On the manufacturer's schedule, usually yearly, more often in hard water.
Why do I get cold water in the middle of a shower?
Low flow, a clogged screen or scale are common causes.
Can a tankless water heater run out of hot water?
It can if demand exceeds its capacity, for example with several fixtures at once.
Is tankless worth repairing?
Usually yes, unless the heat exchanger has failed on an old unit.
