Two installations of the same heater can be very different jobs. One takes a couple of hours and leaves a safe, tested system. The other leaves out the parts that matter. This is what a complete installation includes.
A proper water heater installation includes shutting off and draining the old unit, removing it, setting the new one level on a drain pan, connecting water lines with new shutoffs and connectors, installing a new relief valve with a correct discharge pipe, connecting gas or power safely, venting properly, an expansion tank where required, filling and purging air, testing for leaks, lighting or powering up, and a written work order and invoice.
- Safety parts (relief valve, discharge pipe, gas shutoff, venting) are not optional extras.
- A drain pan matters most above living space.
- A permit and inspection may apply.
- The unit should be tested before the plumber leaves.
- Ask what is in the price before you compare quotes.
The steps
Shut off and drain the old heater: power or gas off, cold water closed, the tank drained.Disconnect and remove it, including the old venting and connections.Check the site. Floor, clearance and any corrosion in the old connections.Set the new heater on a drain pan, level, with a drain line where a leak could do damage.Connect water. New flexible connectors or pipe, isolation valves, and a union where service is easier.Fit the relief valve and run a discharge pipe downward to a safe place.Expansion tank where the system needs one.Gas or electrical. A new gas connector and shutoff valve, or the correct electrical connection.Venting. Correct slope, support and clearances, sealed joints.Fill, purge and test. Air is bled from the lines and every joint is checked for leaks.Start up and check that it fires and heats correctly.Explain and document. The settings, the shutoff locations and a written work order and invoice.
What is often left out
- The drain pan and its drain line
- A discharge pipe that is long enough and routed correctly
- A new gas connector, reusing the old one instead
- An expansion tank where one is needed
- A permit
Questions to ask
- What is included in the price?
- Is a permit included?
- What happens to the old heater?
- Can I see the relief valve and the pipe when you are done?
- Will I get paperwork?
See water heater installation and water heater replacement.
Frequently asked questions
How long does installation take?
For a typical tank replacement, often a few hours, depending on access and changes.
Do I need a permit?
Often. Ask your plumber.
What happens to the old heater?
The plumber normally removes it. Confirm that beforehand.
Is a drain pan required?
Above living space, it should be present.
Can I install my own?
Gas and venting are safety work, so use a licensed plumber.
