Repiping means replacing the water supply pipes in a house. It is a large job that is done once, so it is worth understanding when it makes sense and when repairs are enough.

Quick answer

A house needs repiping when its supply pipes fail repeatedly, corrode inside, leak at several places or have a material known to fail. A single leak is a repair. Repeated leaks in different spots, discolored water, falling pressure and aging galvanized or polybutylene pipe are the signs of a repipe. Modern choices are copper and PEX, and the work involves opening walls at access points, installing the new lines, testing and patching.

Key takeaways
  • One leak is usually a repair. Several leaks in different places point to a repipe.
  • Old galvanized and polybutylene pipes are the usual candidates in older Houston homes.
  • Copper and PEX both last when installed well. The choice depends on budget, access and preference.
  • Expect permits, an inspection and a day or more without water.
  • Get the scope in writing, including who patches walls.

Signs it is time

  • Leaks that keep appearing at new spots
  • Rust-colored or brown water, especially after the water has sat
  • Low pressure throughout the house, not at one tap
  • Pipes that look corroded, flaky or green at joints
  • Pipe material known for trouble, such as galvanized steel of a certain age, or polybutylene
  • A recommendation from an inspector or a plumber who has opened a wall

Repair or repipe

If one section is bad and the rest is sound, a repair is cheaper. If the pipe has failed in several places, or the material is at the end of its life, repairing one failure just moves the next to another spot. A plumber who has looked at several areas of your system can say which applies.

Copper or PEX

  • Copper has a long record, tolerates heat and does not degrade in sunlight. It is joined by soldering or press fittings and costs more.
  • PEX is flexible plastic, quicker to install in tight walls, resists freezing damage better and costs less. It must be kept out of direct sunlight and installed with proper fittings.

Both need good installation. See our pages on copper repiping and PEX repiping.

What happens during a repipe

  1. The plumber maps the system and chooses the route.
  2. Small openings are made in walls and ceilings.
  3. New lines are run to each fixture, and the old ones are disconnected.
  4. The system is pressure tested and inspected.
  5. Openings are patched, or arranged to be patched by a drywall contractor.

Most homes are without water for part of a day, and some for longer, depending on size.

What to ask

  • What material, and why?
  • Who patches and paints, and is it included?
  • Is a permit included, and who meets the inspector?
  • How long will the water be off?
  • What does the price include?

See our repipe specialist service page.

Frequently asked questions

How long does a repipe take?

For a typical house, one to a few days depending on size and access.

Will walls be damaged?

Some openings are needed. A good plumber keeps them small and tells you who repairs them.

Is repiping covered by insurance?

Usually not, unless a sudden event caused the damage. Check your policy.

Can I live in the house during a repipe?

Often yes, though without water for part of each day.

Which is better, copper or PEX?

Both last when installed well. The choice depends on budget, access and preference.