A leak you cannot see is the most expensive kind. It runs for weeks, soaks wood and drywall and shows up as a high bill or a stain. Finding it is a process of elimination, and knowing the steps helps you tell a thorough plumber from a guesser.

Quick answer

Leak detection starts with a meter test: shut off every fixture and check whether the water meter still moves. If it does, the plumber isolates sections of the system, pressure tests the lines, checks the likely spots, and uses listening equipment or a camera to narrow down the location before any wall or slab is opened. The aim is to open the smallest possible area.

Key takeaways
  • A moving water meter with everything off is the first proof of a leak.
  • Where the leak is decides how it is found: supply line, drain line or fixture.
  • Isolating sections shrinks the search before anything is opened.
  • A leak under a slab is found by process and tools, not by drilling at random.
  • Early signs are a high bill, damp patches, mold smell, warm floor spots and the sound of running water.

Signs of a hidden leak

  • A water bill that rises with no change in use
  • A meter that moves when nothing is running
  • Damp, stained or bubbling walls, ceilings or floors
  • Musty smells or visible mold
  • A warm spot on a floor, which can mean a hot water line leaking under it
  • Low pressure or the sound of running water when all taps are closed

The steps a plumber follows

  1. The meter test. All water off inside and out, then the meter is read and checked again after a while.
  2. Check the obvious. Toilets (a dye test shows a leaking flapper), outdoor taps, the water heater and its relief valve, irrigation connections.
  3. Isolate sections. Valves are closed in turn, such as at the house, then at the heater, to see where the meter stops moving.
  4. Pressure test the lines. A gauge shows whether a line holds pressure. A drop points to a leak somewhere along it.
  5. Narrow the location. Listening devices pick up the sound of water escaping through a pipe, and a camera can look inside drain lines. A map of the pipe route helps.
  6. Confirm before opening. The smallest opening that exposes the leak is made, and the repair is done.

Where leaks hide

  • Under a slab, where supply lines run in concrete or in the soil beneath it. Houston's clay shifts, and older copper can corrode. See our page on slab leak repair.
  • In walls and ceilings, from pipes, valves or fixtures.
  • In the yard, between the meter and the house.
  • In drain lines, where sewer water escapes into the soil.

Why it matters to act

Water damage grows quietly. A small leak can rot framing and flooring, feed mold and add a large amount to a water bill over a few months. Once found, many leaks are simple repairs. Others, such as repeated failures in old pipe, point towards replacement. See our leak detection and repipe specialist pages.

Frequently asked questions

How do I check for a leak myself?

Turn everything off, read the water meter, wait twenty minutes and read it again. If the numbers or the small dial have moved, there is a leak.

Can leak detection find a slab leak?

Often yes, by isolating the line, pressure testing and listening to narrow the location.

Will they have to cut into the wall?

Only after the leak is located, and in the smallest area possible.

Is a high water bill always a leak?

No. Seasonal use, irrigation and rate changes also raise bills. The meter test tells you.

How quickly should I act?

As soon as you suspect it. Water damage compounds.