Before you decide whether a house needs new pipes, find out what is already in it. The material, together with the age of the house, tells you most of what you need to know about what might go wrong.

Quick answer

Look at the pipes where they are exposed, such as under a sink, at the water heater or near the meter. Copper is orange-brown or green with soldered joints, galvanized steel is gray and threaded, PEX is flexible plastic in red, blue or white, polybutylene is gray or blue flexible plastic with crimped fittings, and CPVC is rigid cream or yellowish plastic. Age matters: older homes tend to have galvanized steel, houses from the 1980s and 1990s may have polybutylene, and newer ones copper or PEX.

Key takeaways
  • Gray, threaded steel pipe is galvanized and corrodes from the inside.
  • Gray or blue flexible plastic with metal crimp rings may be polybutylene, which has a record of failures.
  • Copper and PEX are the usual materials in modern repipes.
  • The main shutoff and the water heater connections are the easiest places to look.
  • A plumber can confirm the material and say whether it is a concern.

How to identify the pipe

PipeWhat it looks likeTypical age of house
Galvanized steelGray, rigid, threaded joints, often rusty or crustyOlder homes
CopperOrange-brown or green, rigid, soldered jointsMany homes from the mid-century on
PolybutyleneGray or blue, flexible plastic, metal crimp ringsRoughly the 1980s and 1990s
CPVCCream or light yellow, rigid plasticMany homes since the 1980s
PEXRed, blue or white flexible plasticNewer homes and repipes

Check under sinks, in the garage and at the water heater. Tap a pipe with a coin: steel clanks, plastic thuds.

What each one means

  • Galvanized. The zinc coating wears off and rust builds up inside, narrowing the pipe. Symptoms are low pressure and brown water. Leaks at threaded joints are common.
  • Polybutylene. Some homes have had no trouble, while others have had pipes and fittings fail. An inspector or insurer may ask about it, and a plumber can assess it.
  • Copper. Lasts decades, but aggressive water or high pressure can cause pinhole leaks, and corrosion shows as green deposits.
  • CPVC. Becomes brittle with age, and fittings can crack.
  • PEX. Resistant to corrosion and easy to install. Needs the right fittings and protection from sunlight.

What to do with what you find

  • If it is copper, PEX or sound CPVC, keep an eye on the pressure and the joints.
  • If it is galvanized and you have low pressure, rusty water or leaks, plan for replacement.
  • If it is polybutylene, have a plumber assess it.
  • If you cannot tell, ask a plumber to look.

For more on replacement, see our repipe specialist service page, and on the options copper repiping and PEX repiping. To see how a repipe goes, read Houston repiping: a quick guide.

Frequently asked questions

Is polybutylene pipe a problem?

It can be. Failures have been reported, and some insurers ask about it. A plumber can assess your system.

Can I look at my pipes without opening a wall?

Often, yes, at the water heater, under sinks and near the meter.

Is galvanized pipe dangerous?

It is not an immediate hazard, but it corrodes, restricts flow and leaks over time.

How long do copper pipes last?

Many decades in good conditions, though aggressive water can cause pinholes.

Is PEX safe?

It is widely used when installed with the correct fittings and kept out of sunlight.