For a business, a plumbing failure is not a repair problem. It is a closed dining room, a flooded stockroom or a restroom that customers cannot use. Most commercial failures give notice in advance, and a short, regular routine catches them. This guide sets out what to check, how often, and what to hand to a licensed plumber.

Quick answer

A commercial plumbing maintenance routine has four parts: monthly walk-throughs of fixtures, drains and visible pipes; scheduled cleaning of drain lines and grease interceptors, set by the kind of business; annual testing of backflow assemblies by a certified tester, and inspection of water heaters and valves; and written records of everything. The aim is to find leaks, slow drains and aging equipment before they interrupt trading.

Key takeaways
  • Walk the building monthly with a checklist. A staff member can do it in half an hour.
  • Slow drains in a commercial building are a warning, not a nuisance. Clear them before the next peak.
  • Restaurants and food businesses need a schedule for grease lines and interceptors.
  • Backflow assemblies need testing by a certified tester on a schedule.
  • Keep dated records and photos. They help with insurance, landlords and inspections.

Step 1: Walk the building every month

Take a flashlight, a phone and a checklist. Look at:

  • Restrooms. Flush every toilet, run every faucet, check for running water, loose fixtures and stains on the ceiling below.
  • Sinks and prep areas. Look under each one for drips and damp, and check that drains empty at a normal speed.
  • Floor drains. Pour a bucket of water into each and watch how fast it clears. Slow floor drains in a kitchen or mechanical room mean a partial blockage.
  • Water heaters. Look at the pan and floor for moisture, the relief valve pipe for drips, and the tank for rust at the bottom.
  • Exposed pipe and valves. Check for corrosion, wet insulation and valves that will not turn.
  • Meters. Read the water meter when the building is closed. If it moves overnight, something leaks.

Photograph anything you are unsure about and note the date.

Step 2: Schedule the drain work

How often drains need cleaning depends on the business.

  • Restaurants and food service. Kitchen lines carry grease and starch. Many need cleaning on a regular cycle, and grease interceptors need pumping and inspection as the local rules and the volume require. Ask a plumber and your hauler how often.
  • Offices and retail. Restroom lines are the main concern, and an annual cleaning and a camera look at the main line is reasonable for an older building.
  • Multi-tenant buildings. Shared lines back up into the lowest unit first. Regular maintenance of the main line protects the whole building.

A drain camera shows what a cleaning cannot: cracks, offset joints, roots and sags. Our plumbing camera inspection page explains the process, and commercial drain cleaning covers the cleaning methods.

Step 3: Test and inspect once a year

  • Backflow assemblies. These protect the water supply from contamination and generally need testing by a certified tester at least annually, and after any repair. Keep the test reports. See our backflow testing page.
  • Water heaters. Flush them, test the relief valve, check the anode where it applies, and look at the venting and the gas connection.
  • Shutoff valves. Operate every isolation valve once a year so that they do not seize, and replace any that leak or will not close.
  • Fixtures and flush valves. Replace worn parts before they fail. Running toilets are a hidden cost on a water bill.
  • Pressure. High pressure strains fixtures and appliances. A regulator and a gauge are cheap to check.

Step 4: Plan for the big items

Some things are not maintenance but replacement, and they are better on your schedule than an emergency one:

  • A water heater at the end of its life
  • Old galvanized or corroded supply lines
  • A sewer line that has needed repeated cleaning
  • Fixtures that no longer meet accessibility needs

A plumber can give you a short list with a rough order of urgency. See our commercial plumbing services, or plumbing for property managers if you manage several units.

Step 5: Keep records and an emergency plan

  • A file with dated photos, test reports, invoices and work orders for each building
  • A map or notes showing the main shutoff, the cleanout and each water heater
  • Names and numbers of the people who can authorize work
  • A short written plan for what staff do in a burst pipe or a sewer backup: shut off the water, move stock, call the plumber

Frequently asked questions

How often should commercial drains be cleaned?

It depends on the business. Food service often needs a regular cycle, while offices may need an annual cleaning and a camera check. A plumber can recommend a schedule once they have seen the building.

What is a grease interceptor?

A tank that catches fats, oils and grease before they enter the sewer. It needs to be pumped and inspected on a schedule set by volume and local rules.

Do I have to test backflow assemblies?

Generally yes, annually, by a tester certified to do so. Requirements depend on the type of assembly and the local authority.

What are the signs of a leak I cannot see?

A water meter that moves when everything is off, a higher water bill, stains or soft spots on a wall, floor or ceiling, and a musty smell.

Should maintenance records be kept?

Yes. Dated photos, test reports and invoices help with insurance, inspections and landlord discussions.